Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - bbracale

Pages: [1]
1
Serial Tools / Ability to sense additional control signals?
« on: February 03, 2018, 03:14:40 AM »
The "Terminal" function of Serial Tools allows me to set the state of RTS & DTR, and sense CTS & DSR.  I would like to also be able to sense the status of DCD & RI.  Is that possible?

2
Serial Tools / Can't differentiate between two connected serial dongles
« on: January 09, 2018, 03:37:51 AM »
I have two IOGear GUC232A adapters (PL-based) that I use with Serial Tools.  IIRC, in the past when I used the Serial Analyzer function with these adapters, Serial Ports A & B were identified separately (there was some -suffix added to one of the adapters).  Now under Sierra, each port shows up in the dropdown with the same name.  So I'm not sure if the two different ports are actually being differentiated correctly by Serial Tools, and even if they are, it makes it difficult to determine which port is which until the device(s) under test elicit some traffic, which might not always be a desirable scenario. 

I understand that this might be more of a driver/OS thing than a Serial Tools thing, but it would be great if the Serial Tools app could address the issue to the extent possible.

Pages: [1]